The skirt itself is a doddle to make. I cut it out, adding seam allowances as I cut. There are two centre panels (cut on the fold), four side panels, four godets and two yokes (cut on the fold). I then cut the same again in some cotton batiste for lining the skirt - I know it's only a toile, but I still like it to be lined.
I then attach the skirt front to the the front yoke lining, and the skirt back to the back yoke lining, feeling mightily relieved that the pieces go together after my hack job on the pattern pieces. I then seam the skirt front to the skirt back.
I then press the top seam where the shell meets the lining, and seam the shell and lining together just under the elastic to form a casing for it. I continue the seam across the front to make a faux waistband. It would have been a good plan to attach interfacing to the front faux waistband, but I thought of it too late.
I do however remember to do another seam across the elastic casing, which makes the casing look neater and stops the elastic from rolling. On the downside, it makes the skirt virtually unalterable if you ever decide you need to replace the elastic with a longer piece to prolong wear...
Then I seam the godets to the side and centre panels. All seams are pressed and top-stitched as I'm going along. I never used to bother topstitching but I have since realised that omitting this just results in a slightly shoddy looking garment.
I then attach the skirt front to the the front yoke lining, and the skirt back to the back yoke lining, feeling mightily relieved that the pieces go together after my hack job on the pattern pieces. I then seam the skirt front to the skirt back.Next I seam the yoke front and back shells together at the sides, before attaching the yoke lining to the yoke shell, right sides together and pressing the hem of the yoke lining so that I can just top stitch it in place once I've put in the elastic at the waistband
I cut a piece of elastic to cinch in the skirt back and attach it at the top of the skirt, sandwiched between the shell and the lining. I attach it by stitching in the ditch of the side seams of the shell. It would have been a good idea to take a photo of the process, but I forgot.
I then press the top seam where the shell meets the lining, and seam the shell and lining together just under the elastic to form a casing for it. I continue the seam across the front to make a faux waistband. It would have been a good plan to attach interfacing to the front faux waistband, but I thought of it too late.
I do however remember to do another seam across the elastic casing, which makes the casing look neater and stops the elastic from rolling. On the downside, it makes the skirt virtually unalterable if you ever decide you need to replace the elastic with a longer piece to prolong wear...Finally, I hem the skirt and it's done. It isn't as swingy as I wanted, so next time I'll put in quite a bit more flare either by cutting the panels and spreading them, or by cutting and hacking a half-circle skirt block. But the skirt is fine for everyday wear. And Laura seems to like it!
No comments:
Post a Comment